Enphase > Q Aggregator for Enphase IQ Systems - Single-phase Branch Aggregator - ARRA

The Enphase Q Aggregator uses the Field-Wireable Connectors to easily connect cables on the roof without complex wiring. Aggregates up to three fully populated 20 amp branch circuits. Supports solar arrays of up to 11.5kW with a single rooftop aggregator.

Terminations at the Q Aggregator
The Q Aggregator accommodates up to three microinverter AC branch circuits. Connect any open male Q Cable connector to the female connector on the Q Aggregator. The Q Aggregator provides built-in 20 A over-current protection for each microinverter AC branch circuit and the ability to run one combined set of output conductors off the roof, further reducing BOS costs and making wire pulls easier. Optionally, you can attach a male Field Wireable Q Connector to the end of a Q Cable or a raw Q Cable and plug it into the Q Aggregator.

Mechanical

Features

• Easy installation and high compatibility.
• Q-Aggregator lets you install systems up to 11.5 kW with only two line conductors and a ground coming from the roof
• Usable in any position up to 45 degrees from horizontal (NEMA 3R, includes drain holes)
• The aggregator bracket is ready to install on the rail, can be flipped for roof or block mount installs and allow you to fit conduit into either or both sides.
• Reduces electrical labor and balance-of-system materials costs
• UL listed

Detailed Description

Use the Q Aggregator to reduce electrical labor requirements and eliminate otherwise necessary BOS components for safer and faster Enphase IQ system installations.

The Q Aggregator is designed to attach to rail, so as to be hidden under a module, for a cleaner looking installation with out external junction boxes. The Q Aggregator home run lands on a single 60 amp breaker at the load center.

Also known as: