ProSolar Aluminum Flashing and Collar

Aluminum flashing and collage for FastJack E Series standoffs.

Detailed Description

The patented design of the FastJack E-Series is the most efficient and cost-effective product of its kind. The FastJack E-Series has been laboratory tested to 3,600 pounds of vertical pullout strength using a single stainless steel lag bolt (included). Product constructed of only high-quality solid aluminum and stainless steel for corrosion resistance and high strength.

• Easy to install
• Patented single lag bolt design Patent No. 6,360,491
• Independently laboratory tested to 3,600 lbs ultimate pull out, 1,380 lbs ultimate side axial loads
• Lightweight and corrosion resistant Aluminum and Stainless Steel materials (no inferior ferrous metals which rust and weaken over time)
• Solid Aluminum post prevents water funneling down through top of post
• No welds to corrode or break
• Designed for the Experienced high volume installer
• 3/16" pilot hole drill guide accessory available
• Available in 3" and 4-1/2" tall sizes
• 1" OD post diameter (1-1/2" OD base diameter) compatible with standard 3/4" UPC / NES approved flashings (no expensive custom flashings required)
• Leveling kit available to accommodate roof height variation

Benefits

• Removable post makes installation on existing roofs quick and easy as flashing can be installed with no post obstruction
• Patented design locates the lag bolt directly below the stanchion, providing superior strength values
• Precision machined from aluminum, no welds to corrode or break
• Significantly lighter than steel for installer convenience and reduced shipping costs
• Base design works with all standard roof flashings